Ride Diagnosis - Too Soft

Did you review the General Description and perform the necessary inspections? If so, go to step 2 . If not, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
Verify that the ride is too soft. Does the vehicle ride normally? If so, system is OK. If not, go to step 3 .
Inspect the tires for the proper inflation pressure. Is the tire inflation pressure correct? If so, go to step 5 . If not, go to step 4 .
Inflate the tires to the correct pressure. Did you complete the repair? If so, go to step 5 .
Inspect the vehicle trim height. Refer to TRIM HEIGHT INSPECTION PROCEDURE . Repair as necessary. Did you complete the inspection/repair? If so, go to step 6 .
Inspect the following suspension components for wear or damage.
- Springs
- Struts
- Shock Absorbers
Refer to STRUTS OR SHOCK ABSORBERS ON-VEHICLE TESTING . Are any of the components the worn or damaged? If so, go to step 7 . If not, go to step 8 .
Replace all of the worn or damaged components.
- For shock absorber replacement, refer to SHOCK ABSORBER for Front Suspension or SHOCK ABSORBER for Rear Suspension.
- For spring replacement, refer to TRANSVERSE SPRING for Front Suspension or TRANSVERSE SPRING for Rear Suspension.
Did you complete the repair? If so, go to step 8 .
Inspect the real time damping system. Refer to DIAGNOSTIC SYSTEM CHECK - REAL TIME DAMPING . Repair as necessary. Did you complete the inspection/repair? If so, go to step 9 .
Drive the vehicle in order to verify the repair. Did you correct the condition? If so, system is OK. If not, go to step 3 .