LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Corvette Z06 >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Ball Joint Stud Nut (1)
  Lower
Step 1 15 (20)    
Step 2 Additional 210 degrees    
Step 3 41 (55)    
  Upper
Step 1 15 (20)    
Step 2 Additional 250 degrees    
Step 3 41 (55)    
Crossmember Mount Nut 81 (110)
Hub & Bearing Assembly Nut 96 (130)
Lower Control Arm Mounting Bolt (2) 125 (170)
Lower Engine Mount Nut 48 (65)
Power Steering Gear Mounting Bolt 74 (100)
Shock Absorber Bolt
  Lower 21 (28)
  Upper 19 (26)
Spring Retainer Bolt (2) 46 (62)
Stabilizer Bar
  Insulator Bracket Bolt (At Frame) (2) 43 (55)
  Link Nut (2) 53 (72)
Tie Rod Jam Nut 44 (60)
Tie Rod-To-Steering Knuckle Nut (1)
  Step 1 15 (20)
  Step 2 Additional 160 degrees
  Step 3 33 (45)
Upper Control Arm-To-Frame Nut 48 (65)
Wheel Lug Nut 100 (136)
(1) After tightening nut to specification, tighten nut further but only as far as necessary to align cotter pin holes. DO NOT loosen nut to align holes. Install cotter pin from rear toward front of vehicle.
(2) Tighten with vehicle at proper trim height.