LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Analog Instrument Panels >> System Tests >> Test R: Heads-Up Display Hazard Indicators Inoperative

Test R: Heads-Up Display Hazard Indicators Inoperative

  1. If IPC diagnostic system check was performed, go to next step. If IPC diagnostic system check was not performed, go to INSTRUMENT PANEL CLUSTER DIAGNOSTIC SYSTEM CHECK  . After performing IPC diagnostic system check, go to next step.
  2. Check operation of IPC hazard indicators. If IPC hazard indicators are operating properly, problem may be intermittent. To diagnose intermittent, go to TESTING FOR INTERMITTENT AND POOR CONNECTIONS . If HUD does not dim properly, go to next step. If IPC hazard indicators are not operating properly, go to next step.
  3. Turn ignition off. Disconnect IPC connectors. See INSTRUMENT PANEL CLUSTER  . Turn ignition on. Turn hazard switch on. Connect test light between ground and IPC connector terminal B6 (Gray/Black wire). See Figure . If test light illuminates, go to next step. If test light does not illuminate, go to step  5 .
  4. Replace IPC. See INSTRUMENT PANEL CLUSTER  . After repairs, go to step  7 .
  5. Disconnect hazard warning switch connector. See HAZARD WARNING SWITCH  . Check for open in Gray/Black wire between IPC connector terminal B6 and hazard warning switch connector terminal "E". Repair as necessary. After repairs, go to step  7 . If circuit is okay, go to next step.
  6. Replace hazard warning switch. After repairs, go to next step.
  7. Recheck system operation to verify the repair. If system operates properly, repair is complete. If system does not operate properly, go to step  3 .
scientia non olet · About LEMON Manuals