Removal & Installation (Passenger-side)

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
Remove passenger-side knee bolster. Remove Connector Position Assurance (CPA) clip from passenger-side air bag module Yellow 2-pin connector and disconnect connector. See Fig 2. Remove passenger-side air bag module mounting bolts. Remove passenger-side air bag module from instrument panel.
To install, reverse removal procedure. Tighten passenger-side air bag module mounting bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system.

Fig 1: Removing Driver-side Air Bag Module

Courtesy of GENERAL MOTORS CORP.

Fig 2: Identifying Passenger-side Air Bag Module

Courtesy of GENERAL MOTORS CORP.