Stoplight Switch: Removal
CAUTION:
Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
- Disconnect the battery negative cable.
- Disconnect the electrical connector from the stoplight switch. See Fig 1 . Remove the retainer from the brake pedal pin.
- Remove the stoplight switch and the pushrod to the power brake booster from the brake pedal pin. Unsnap the stoplight switch from the power brake booster pushrod. See Fig 1 .