Removal (Delco 3486)

The use of GM brake pad material will help to maintain a balance between the front and the rear brake performance. In addition, the use of GM brake pad material will provide the proper brake balance for the purposes of stopping distance and control over the full range of operating conditions. The installation of any front brake pads or rear brake shoe material with a performance different from that of the suggested GM replacement parts for this vehicle may change the intended brake balance of this vehicle.

1. Raise the vehicle. Support the vehicle with suitable safety stands. Remove the tire and wheel assembly.
2. Remove the front brake caliper from the front brake rotor. See BRAKE CALIPER  .
3. Remove the front outboard brake pad. Use a suitable flat-bladed tool to disengage the bottoms on the front brake pad from the holes in the front brake caliper housing.
4. Remove the front inboard brake pad.
5. Replace any corroded caliper bolts, bushings, or sleeves. Replace any nicked or cut caliper bolt bushings or seals.