LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> C3500 HD 8.1 G, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1688 (Disc Brakes (Except Cab & Chassis, & Hd)) >> Repair Instructions >> Rear Brake Rotor Replacement (Dual Wheels) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the hub and the rotor, if applicable
  2. Press the wheel studs into the hub and rotor assembly
  3. Install the hub and rotor assembly. Refer to Hub and Rotor Assembly Replacement in Rear Drive Axle
  4. Install the tire and wheel assembly
  5. Lower the vehicle
  6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance
  7. Slowly release the brake pedal
  8. Wait 15 seconds, then repeat steps 5-6 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads
  9. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to MASTER CYLINDER RESERVOIR FILLING in Hydraulic Brakes.
scientia non olet · About LEMON Manuals