LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> C3500 HD 8.1 G, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1688 (Disc Brakes (Except Cab & Chassis, & Hd)) >> Repair Instructions >> Rear Brake Backing Plate Replacement (25/35 Series) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake
  2. Raise and support the vehicle
  3. Remove the tire and wheel assembly
    4. Fig 1: Park Brake Cable Equalizeer Nut
    GM791554
  4. Relieve the tension from the park brake cables by loosening the nut at the equalizer
  5. Remove the rear park brake cable from the park brake actuator lever
  6. Remove the park brake cable from the mounting bracket by depressing the locking tabs
  7. Remove the rotor. Refer to Rear Brake Rotor Replacement (Except Dual Wheels or NYS) , Rear Brake Rotor Replacement (Dual Wheels)   or Rear Brake Rotor Replacement (W/NYS - 4-Wheel Steering) 
  8. Remove the axle shaft. Refer to REAR AXLE SHAFT REPLACEMENT (8.6 & 9.5 INCH AXLES) or REAR AXLE SHAFT REPLACEMENT (9.75 INCH AXLE)
  9. Remove the park brake shoe. Refer to Parking Brake Shoe Replacement (15/25/35 Series - Except RPO NYS - 4-Wheel Steering) 
    10. Fig 2: View Of Backing Plate & Nuts - Rear
    GM370688
  10. Remove the backing plate nuts
  11. Remove the backing plate from the axle housing flange
scientia non olet · About LEMON Manuals