LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> C3500 HD 8.1 G, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1688 (Disc Brakes (Except Cab & Chassis, & Hd)) >> Repair Instructions >> Parking Brake Shoe Replacement (15/25/35 Series - Except RPO NYS - 4-Wheel Steering) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle
  2. Remove the tire and the wheel
  3. Relieve the tension on the park brake cables by loosening the nut at the equalizer
  4. Remove the park brake cable from the park brake actuator lever
  5. Remove the rotor. Refer to Rear Brake Rotor Replacement (Except Dual Wheels or NYS)  or Rear Brake Rotor Replacement (Dual Wheels)  
    6. Fig 1: Locating Adjustment Screw, Park Brake Shoe & Retaining Spring
    GM370485
  6. Turn the adjustment screw (1) to the fully home position in the notched adjustment nut
  7. Remove the park brake shoe assembly from the backing plate by removing the tips from the slots and sliding the shoe (2) towards the retaining spring (3) until the shoe disengages from the spring
  8. Remove the park brake shoe assembly from the vehicle by placing one of the open ends of the shoe over the axle flange and rotating the shoe until it has cleared the flange.
scientia non olet · About LEMON Manuals