LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> C3500 HD 6.5 F, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Diagnostic Information and Procedures >> Disc Brake Mounting and Hardware Inspection - Front

Disc Brake Mounting and Hardware Inspection - Front

  1. Remove the disc brake caliper from the caliper mounting plate.
  2. Remove the disc brake pads from the caliper.
    3. Fig 1: Support Key, Spring & Caliper Lock Mounting Bolt
    GM156332Courtesy of GENERAL MOTORS CORP.
  3. Inspect the disc brake pad mounting hardware (1, 3) for the following:
    • Missing mounting hardware
    • Excessive corrosion
    • Bent mounting tabs
    • Looseness at the caliper mounting bracket
    • Looseness at the disc brake pads
  4. If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.
  5. Ensure the disc brake pads are held firmly in place on the caliper mounting bracket.
  6. Install the disc brake pads to the caliper mounting bracket.
  7. Install the disc brake caliper to the mounting plate.
scientia non olet · About LEMON Manuals