Installation Procedure
- Slide the cupholder onto the metal track in the instrument panel.
- Install the cupholder retainer from underneath the instrument panel by twisting the retainer to the right.
- Slide the cupholder into the instrument panel.NOTE: Refer to FASTENER NOTICE .
- Install the two rear screws to the cupholder
Tighten
Tighten the screws to 2 N.m (18 lb in), while holding the cupholder face plate against the cluster bezel opening to assure proper alignment.
- Install the ashtray. Refer to Ashtray Replacement .
- Install the knee bolster. Refer to Knee Bolster Replacement .