LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tires & Wheels >> Repair Instructions >> Tire Hoist and Shaft Replacement (Pickup) >> Installation Procedure

Installation Procedure

  1. Install the hoist to the rear crossmember. Align the hoist with the rear crossmember and the shaft.
  2. Install the pin and the retainer.
  3. Install the hoist mounting bolts.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the hoist mounting nuts.

    Tighten 

    Tighten the hoist mounting nuts to 26 N.m (19 lb ft).

  5. Lower the vehicle.
  6. Install the spare tire to the carrier.
    Fig 1: Installing Spare Tire From Tire Carrier (Pickup)
    G01670592Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals