LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - General Diagnosis >> Diagnostic Information >> Ride Diagnosis - Too Soft

Ride Diagnosis - Too Soft

  1. Did you review the General Description and perform the necessary inspections? If yes, go to next step. If no, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
  2. Verify that the ride is too soft. Does the vehicle ride normally? If yes, system is okay. If no, go to next step.
  3. Inspect the tires for the proper inflation pressure. Is the tire inflation pressure correct? If yes, go to step  5. If no, go to next step.
  4. Inflate the tires to the correct pressure, then go to next step.
  5. Inspect the vehicle trim height. Refer to TRIM HEIGHT INSPECTION PROCEDURE . Repair as necessary. After inspection/repair, go to next step.
  6. Inspect the front coil springs, front and rear shock absorbers, and leaf springs for wear or damage. Refer to STRUTS OR SHOCK ABSORBERS ON-VEHICLE TESTING . Are any of the components the worn or damaged? If yes, go to next step. If no, go to step  8.
  7. Replace all of the worn or damaged components. After repairs, go to next step.
  8. Drive the vehicle in order to verify the repair. Did you correct the condition? If yes, system is okay. If no, go to step  3.
scientia non olet · About LEMON Manuals