LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - General Diagnosis >> Diagnostic Information >> Noise Diagnosis - Rear Suspension

Noise Diagnosis - Rear Suspension

DEFINITION: Any noise emitted from the rear of the vehicle that is induced by VEHICLE SPEED or DRIVING TERRAIN as related to the rear suspension.

  1. Did you review the General Description and perform the necessary inspections? If yes, go to next step. If no, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
  2. Verify that the rear suspension is noisy. Is the rear suspension noisy? If yes, go to next step. If no, system is okay.
  3. Shift the transmission into Park. Turn the ignition off. Bounce the rear of the vehicle in order to duplicate the noise. Is the complaint noise present? If yes, go to next step. If no, go to step  5.
  4. Bounce the rear of the vehicle. Use a J 39570 Chassis Ear or equivalent in order to locate the source of the noise. See SPECIAL TOOLS . Repair or replace the suspect components as necessary. After repairs, go to step  15.
  5. Raise and support the vehicle. Inspect all of the rear suspension components for any damage. Are any components damaged? If yes, go to next step. If no, go to step  7.
  6. Repair or replace any damaged components. Go to step  15.
  7. Inspect the tires for proper inflation. Correct the tire inflation pressure as necessary. Inspect the tires for unusual wear. Does either tire exhibit unusual tread wear? If yes, go to next step. If no, go to step  10.
  8. Rotate the tires. Road test the vehicle. Is the noise now emitted from the front of the vehicle? If yes, go to next step. If no, go to step  10.
  9. Replace the tires that are causing the noise. Go to step  15.
  10. Ensure that the park brake cable and the spare tire are secured properly. Did you service any components? If yes, go to step  15. If no, go to next step.
  11. Ensure that all of the wheel nuts are tightened to the correct specification. Tighten as necessary. Did you tighten any of the wheel nuts? If yes, go to step  15. If no, go to next step.
  12. Raise and support the vehicle. Use your hand to push and pull the shock absorbers. Is either shock absorber loose? If yes, go to next step. If no, go to step  15.
  13. Inspect the shock absorber fasteners for the correct fastener tightening specification. Tighten as necessary. Use your hands in order to push and pull the shock absorber. Is the shock absorber loose? If yes, go to next step. If no, go to step  15.
  14. Replace the loose or worn shock absorber. After repairs, go to step  15.
  15. Operate the system in order to verify the repair. Did you correct the condition? If yes, system is okay. If no, go to step  3.
scientia non olet · About LEMON Manuals