LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Removal & Installation >> Stabilizer Bar (AWD) >> Removal

Stabilizer Bar (AWD): Removal

  1. Raise the vehicle on a hoist.
  2. Remove the lower nuts, the washers, and the bolts from the stabilizer link. See Fig 1.
  3. Remove the nuts from the U-bolts. See Fig 2.
  4. Remove the U-bolts, the clamps, and the insulators.
  5. Remove the stabilizer bar.
Fig 1: Removing Rear Stabilizer Link
G00137979Courtesy of GENERAL MOTORS CORP.
Fig 2: Installing Rear Stabilizer Bar U-Bolts
G00137980Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals