LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Removal & Installation >> Stabilizer Bar (2WD) >> Installation

Stabilizer Bar (2WD): Installation

  1. Install the stabilizer bar to rear axle. See Figure.
  2. Install the insulators, the clamps, and the U-bolts.
  3. Install the nuts to the U-bolts, and tighten. See TORQUE SPECIFICATIONS .
  4. Install the stabilizer bar to link mounting bolt.
  5. Install the stabilizer bar to the link nut. See Figure.
  6. Tighten the upper link nut.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals