LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Removal & Installation >> Stabilizer Bar (2-Door Utility) >> Installation

Stabilizer Bar (2-Door Utility): Installation

  1. Install the stabilizer bar to the rear axle. See Figure.
  2. Install the insulators, the clamps, and U-bolts.
  3. Install the nuts to the U-bolts; Then tighten the nuts. See TORQUE SPECIFICATIONS .
  4. Install the stabilizer bar to the link mounting bolt. See Figure.
  5. Install the stabilizer bar to the link nut; Then tighten the upper link nut.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals