LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Restraints >> Seat Belts >> Supplemental Inflatable Restraint System Deactivation Procedures >> General Motors >> Disabling & Activating Air Bag System >> Activating System (Impala & Monte Carlo)

Activating System (Impala & Monte Carlo)

  1. Make sure SDM fuse is not installed and key is out of ignition switch. Connect the driver side air bag 2-pin Yellow air bag connector. Connector is located under rear of driver's seat. Install CPA clip.
  2. Connect passenger air bag Yellow air bag connector at far right end of instrument panel. Install CPA clip. Connect driver air bag Yellow air bag connector at base of steering column. Install CPA clip.
  3. Install SDM fuse in fuse block. Staying well away from air bag modules, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times, and then turns off.
scientia non olet · About LEMON Manuals