LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Restraints >> Seat Belts >> Supplemental Inflatable Restraint System Deactivation Procedures >> General Motors >> Disabling & Activating Air Bag System >> Activating System (DeVille & Seville)

Activating System (DeVille & Seville)

  1. Remove key from ignition switch. Ensure SIR fuse is still removed from fuse block. On DeVille with optional rear air bags, connect the passenger rear air bag Yellow connector to the vehicle harness. Install CPA clip. Connect driver rear air bag Yellow 2-pin connector to vehicle harness. Install CPA clip. Install rear seat back.
  2. On all models, connect driver side air bag and seat belt pretensioner Yellow connector to vehicle harness. Install CPA clip. Connect passenger side air bag and seat belt pretensioner Yellow connector to vehicle harness. Install CPA clip.
  3. Connect passenger front air bag Yellow connector to vehicle harness. Install CPA clip. Install passenger-side sound insulator. Connect driver front air bag Yellow connector to vehicle harness at base of steering column. Install CPA clip. Install sound insulator panel.
  4. Install SIR fuse in fuse block. Install rear seat. Staying well away from air bag modules, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times (6-10 times on DeVille), and then turns off.
scientia non olet · About LEMON Manuals