LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Restraints >> Seat Belts >> Supplemental Inflatable Restraint System Deactivation Procedures >> Ford Motor Co. >> Disabling & Activating Air Bag System >> Disabling System (Explorer & Mountaineer)

Disabling System (Explorer & Mountaineer)

  1. Record preset radio frequencies for reprogramming (if equipped). Disconnect negative battery cable. Wait at least one minute for backup power supply to deplete stored energy.
  2. Remove driver's air bag module. See DRIVER AIR BAG MODULE . Connect appropriate air bag simulator to clockspring connector at top of steering column (in place of air bag). See AIR BAG SIMULATOR .
  3. Remove glove box. Disconnect passenger air bag connector. Connect appropriate air bag simulator to passenger's air bag vehicle harness connector (in place of air bag). See AIR BAG SIMULATOR . For models equipped with side air bags, go to next step. If vehicle is not equipped with side air bags, connect negative battery cable.
  4. Separate passenger side "C" pillar trim panel. Disconnect passenger side air bag connector, located on "C" pillar behind second row safety belt shoulder height adjuster. Connect appropriate side air bag simulator (in place of air bag). See AIR BAG SIMULATOR . Repeat procedure for driver side air bag. Connect negative battery cable.
scientia non olet · About LEMON Manuals