Latched DTC B1018, B1024 Notice (SDM-RSD)

NOTE: When DTC B1018 or B1024 has been set it is necessary to replace the inflatable restraint Sensing & Diagnostic Module (SDM). Setting DTC B1018 or B1024 will also cause DTC B1071 to set. When a scan tool clear codes command is issued & the malfunction is no longer present, DTC B1018 or B1024 & DTC B1071 will remain current. Make sure that the short to ground condition is repaired prior to installing a replacement SDM to avoid damaging the SDM.