LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> General Motors (Cars) >> Crankshaft Position Sensor System Variation Learn Procedure >> Camaro & Firebird - 5.7L

Camaro & Firebird - 5.7L

NOTE: While the learn procedure is in progress, release the throttle immediately when the engine starts to decelerate. The engine control is returned to the operator and the engine responds to throttle position after the learn procedure is complete.
  1. Install a scan tool.
  2. Apply the parking brake.
  3. Block the drive wheels.
  4. Close the hood.
  5. Place the transmission in Park if the vehicle has an automatic transmission, or in Neutral if the vehicle has a manual transmission.
  6. Idle the engine until the engine coolant temperature reaches 150°F (66°C).
  7. Turn OFF all of the accessories.
  8. Apply the brakes for the duration of the procedure.
    9. NOTE: If the CKP System Variation Learn Procedure cannot be completed successfully, see appropriate SELF-DIAGNOSTICS article.
  9. Use the scan tool in order to enable the Crankshaft Position System Variation Learn Procedure.
  10. Slowly raise the engine speed to 4000 RPM.
  11. Immediately release the throttle when the engine speed decreases.
  12. Turn OFF the ignition for 15 seconds after the learn procedure is completed successfully.
scientia non olet · About LEMON Manuals