LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - NV 3500) >> Repair Instructions >> Transmission Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to LIFTING & JACKING THE VEHICLE in General Information.
  2. Remove the nut holding the rear engine mount to the transmission support.
    Fig 1: Locating Rear Engine Mount-To-Transmission Support Nut
    G01840505Courtesy of GENERAL MOTORS CORP.
  3. Remove the mount to transmission bolts.
    Fig 2: Locating Rear Engine Mount-To-Transmission Bolts
    G01840506Courtesy of GENERAL MOTORS CORP.
  4. Raise the transmission using a suitable transmission jack, just enough in order to permit the removal of the mount.
  5. Remove the mount.
    Fig 3: Locating Transmission Mount
    G01840507Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals