Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the mount.

Fig 1: Locating Transmission Mount
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the transmission mount to transmission bolts.
Lower the transmission.
Tighten

Tighten the bolt to 50 N.m (37 lb ft).

Fig 2: Locating Rear Engine Mount-To-Transmission Bolts
Courtesy of GENERAL MOTORS CORP.
Install the nut holding the rear engine mount to the transmission support.
Tighten

Tighten the nut to 45 N.m (33 lb ft).

Fig 3: Locating Rear Engine Mount-To-Transmission Support Nut
Courtesy of GENERAL MOTORS CORP.
Lower the vehicle.