LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - NV 3500) >> Repair Instructions >> Transmission Housing Oil Seal Replacement (Front Seal) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission. Refer to TRANSMISSION REPLACEMENT .
  2. Remove the 2 clutch actuator bolts.
  3. Remove the clutch actuator from the input shaft.
    Fig 1: Locating Clutch Actuator & Bolts
    G01840511Courtesy of GENERAL MOTORS CORP.
  4. Remove the 6 bolts from the front bearing retainer.

    Carefully remove the front bearing retainer.

    Fig 2: Locating Front Bearing Retainer & Bolts
    G01840512Courtesy of GENERAL MOTORS CORP.
  5. Remove the seal from the front bearing retainer by using a hammer and a punch.
    Fig 3: Removing Front Bearing Retainer Seal
    G01840513Courtesy of GENERAL MOTORS CORP.
  6. Remove the old gasket material from the front bearing retainer.
scientia non olet · About LEMON Manuals