Clutch Assembly & Pilot Bearing: Removal
WARNING: This page is about a different variant/trim than selected.
- Raise and support vehicle. Remove transmission. See TRANSMISSION . Remove slave cylinder and release bearing. Install Clutch Aligner (J-33169) to support clutch disc. Mark flywheel, clutch disc and pressure plate for reassembly reference.
- Evenly loosen pressure plate bolts 1-2 turns at a time until clutch plate spring tension is released. Remove clutch disc and pressure plate. Remove clutch aligner. Using Pilot Bearing Puller (J-43276), remove pilot bearing if worn or damaged.