LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 999 (Automatic Transmission - ALLISON (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission mount to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Locating Transmission Mount Bolts
    GM702771Courtesy of GENERAL MOTORS CORP.
  2. Install the transmission mount to the transmission or transfer case adapter mounting bolts (1).

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: Identifying Transmission Mount Nuts
    GM647997Courtesy of GENERAL MOTORS CORP.
  3. Lower the transmission.
  4. Install the transmission mount to the transmission support retaining nut or nuts.

    Tighten:  Tighten the nut or nuts to 40 N.m (30 lb ft).

  5. Remove the transmission jack.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals