LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 999 (Automatic Transmission - ALLISON (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Fluid Cooler Connector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Transmission Oil Cooler Pipe Connectors
    GM659002Courtesy of GENERAL MOTORS CORP.
  1. Install new transmission oil cooler pipe connectors (1) and (2).

    Tighten:  Tighten to 25 N.m (18 lb ft).

  2. Connect the hose to the transmission oil cooler pipe connectors.
scientia non olet · About LEMON Manuals