LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 999 (Automatic Transmission - ALLISON (Introduction, Service & Replacement)) >> Repair Instructions >> Torque Converter Housing Bolt Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new seals on any bolts (1) removed.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Torque Converter Housing Bolts
    GM659006Courtesy of GENERAL MOTORS CORP.
  2. Install any bolts (1) removed.

    Tighten:  Tighten bolts to 56 N.m (41 lb ft).

  3. Install the torque converter into the transmission. Refer to Torque Converter Replacement .
scientia non olet · About LEMON Manuals