LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 999 (Automatic Transmission - ALLISON (Introduction, Service & Replacement)) >> Repair Instructions >> Control Valve Body Cleaning and Inspection >> Pressure Control Valve Retaining Bracket Inspection

Pressure Control Valve Retaining Bracket Inspection

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the angle between the surfaces of the pressure control valve retaining bracket (1), as shown in insert, angle A.
    Fig 1: Measuring The Angle Between The Surfaces Of The Pressure Control Valve Retaining Bracket
    GM795294Courtesy of GENERAL MOTORS CORP.
  2. Adjust the bracket surfaces until the angle between the surfaces is 82.84 degrees.
scientia non olet · About LEMON Manuals