LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 998 (Transfer Case - NVG 263-NP1) >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transfer case shield to the crossmember, if equipped.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transfer case shield bolts, if equipped.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    3. Fig 1: Installing Transfer Case Shield & Bolts
    GM396828Courtesy of GENERAL MOTORS CORP.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals