LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 998 (Transfer Case - NVG 263-NP1) >> Repair Instructions >> Transfer Case Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (away from the body of the transfer case).
  1. Align the input seal evenly on the input shaft.
    IMPORTANT: The input shaft seal should be even with the surface of the transfer case after installation.
  2. Using the J 42738  , install the input shaft seal.
    3. Fig 1: Installing Transfer Case Input Shaft Seal
    GM678288Courtesy of GENERAL MOTORS CORP.
  3. Install the transfer case. Refer to Transfer Case Adapter Replacement .
  4. Check the fluid level, add fluid if necessary.
scientia non olet · About LEMON Manuals