LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 998 (Transfer Case - NVG 263-NP1) >> Repair Instructions >> Transfer Case Fluid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Fastener Notice in Cautions and Notices.
IMPORTANT: Use only drain and fill plugs that are made from aluminum. Steel or brass plugs are not compatible with the magnesium case.
  1. Install the drain plug.

    Tighten:  Tighten the plug to 20 N.m (15 lb ft).

    2. Fig 1: View Of Transfer Case Drain Plug
    GM660282Courtesy of GENERAL MOTORS CORP.
  2. Fill the transfer case to the bottom of the fill plug hole with the approved fluid.
  3. Install the fill plug.

    Tighten:  Tighten the plug to 20 N.m (15 lb ft).

    4. Fig 2: View Of Transfer Case Fill Plug
    GM660281Courtesy of GENERAL MOTORS CORP.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals