LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 998 (Transfer Case - NVG 263-NP1) >> Repair Instructions >> Transfer Case Encoder Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  2. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  3. Disconnect the encoder motor electrical connector.
    4. Fig 1: Disconnecting Encoder Motor Electrical Connector
    GM715660Courtesy of GENERAL MOTORS CORP.
  4. Remove the encoder motor bolts.
  5. Remove the encoder motor.
    6. Fig 2: Removing Encoder Motor & Bolts
    GM857301Courtesy of GENERAL MOTORS CORP.
  6. Remove the actuator insulator gasket.
  7. If replacing the encoder motor, remove the locating pins from the old motor.
scientia non olet · About LEMON Manuals