LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 997 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Speed Sensor Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the front speed sensor.

    Tighten:  Tighten the speed sensor to 15 N.m (11 lb ft).

    2. Fig 1: View Of Vehicle Speed Sensor
    GM662047Courtesy of GENERAL MOTORS CORP.
  2. Connect the front speed sensor electrical connector (5).
    3. Fig 2: Front Speed Sensor Electrical Connector
    GM651506Courtesy of GENERAL MOTORS CORP.
  3. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
scientia non olet · About LEMON Manuals