LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 997 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the selector switch close to the housing so the electrical connectors can be connected.
    2. Fig 1: Installing Selector Switch To Housing
    GM396838Courtesy of GENERAL MOTORS CORP.
  2. Connect the selector switch electrical connectors (2, 3).
    3. Fig 2: Connecting Selector Switch Electrical Connectors
    GM830158Courtesy of GENERAL MOTORS CORP.
  3. Slide the selector switch into the housing until the switch snaps into place.
    IMPORTANT: Make sure that the selector switch is seated properly in the housing before installing the I/P cluster bezel.
  4. Install the I/P cluster bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals