LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Rear Wheel Steering System) >> Repair Instructions >> Steering Gear Actuator Boot Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When lifting the vehicle do not allow the jack to touch the rear steering gear. If the jack touches the rear steering gear you may damage the gear or the rack and pinion boots. If the boots are damaged replace the rack and pinion boot.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Unsnap the locking tabs on the rack and pinion boot protector (1).
    Fig 1: Unsnaping The Locking Tabs On The Rack And Pinion Boot Protector
    GM907122Courtesy of GENERAL MOTORS CORP.
  3. Remove the rack and pinion boot protector (1) from the rack and pinion boot (2).
scientia non olet · About LEMON Manuals