LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Rear Wheel Steering System) >> Repair Instructions >> Steering Gear Actuator Boot Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rack and pinion boot protector (1) to the rack and pinion boot (2).
    Fig 1: Installing Rack And Pinion Boot Protector To The Rack And Pinion Boot
    GM907122Courtesy of GENERAL MOTORS CORP.
  2. Snap the locking tabs together on the rack and pinion boot protector.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals