LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Rear Wheel Steering System) >> Repair Instructions >> Rear Wheel Steering Tie Rod End Replacement - Inner >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the inner tie rod to the steering gear.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Using theJ 44665-2  (2), tighten the inner tie rod (1).

    Tighten:  Tighten the inner tie rod to 100 N.m (74 lb ft).

    Fig 1: Using J 44665-2 (2) To Tighten The Inner Tie Rod
    GM750942Courtesy of GENERAL MOTORS CORP.
  3. Install the inner tie rod support clamp to the steering gear. Use the J 44665-1  (1) and the J 44665-2  (2) in order to tighten the inner tie rod support clamp.

    Tighten:  Tighten the inner tie rod support clamp to 25 N.m (18 lb ft).

    Fig 2: Tightening The Inner Tie Rod Support Clamp
    GM747754Courtesy of GENERAL MOTORS CORP.
  4. Install the rack and pinion boot to the steering gear. Refer to Rack and Pinion Boot Replacement .
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
  7. Perform a four wheel alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.
scientia non olet · About LEMON Manuals