Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the lower ball joint (2) to the vehicle.

Fig 1: Installing Lower Ball Joint To The Vehicle
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: Installing Bolts Retaining The Lower Ball Joint To The Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Install the bolts (2) retaining the lower ball joint (3) to the steering knuckle.
Tighten: Tighten the bolts to 110 N.m (81 lb ft).
Install the lower ball joint pinch bolt (1).
Tighten: Tighten the bolt to 230 N.m (169 lb ft).

Fig 3: Installing Snap Ring To The Lower Ball Joint

Courtesy of GENERAL MOTORS CORP.

Install the snap ring (2) to the lower ball joint.
Install the bolt (8) and nut (2) retaining the bracket to the axle.
Tighten: Tighten the retaining bolt and nut to 25 N.m (18 lb ft).

Fig 4: Installing The Bolt And Nut Retaining The Bracket To The Axle
Courtesy of GENERAL MOTORS CORP.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.
Perform a four wheel alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.