LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Rear Wheel Steering System) >> Diagnostic Information and Procedures >> DTC C0532: Rear Wheel Steering Module - Invalid Motor Position >> Test Description

Test Description

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step tests for the proper operation of the rear steering position sensor.
  2. 3:  This step tests for the proper operation of the rear steering motor position sensor.
  3. 4:  This step performs the diagnostic procedure for the rear steering position sensor.
  4. 5:  This step performs the diagnostic procedure for the rear steering motor position sensor.
DTC C0532

Step Action Yes No
Schematic Reference:  Rear Wheel Steering Schematics  
Connector End View Reference:  Rear Wheel Steering Connector End Views  
1 Did you perform the Diagnostic System Check-Rear Wheel Steering? Go to Step 2  Go to Diagnostic System Check - Rear Wheel Steering 
2 
  1. Install a scan tool.
  2. Turn the ignition switch to the ON position, with the engine ON.
  3. With a scan tool, select the Display DTC function on the scan tool.
Does the scan tool display DTC C0522 along with DTC C0532?		 Go to Step 4  Go to Step 3 
3  Does the scan tool display DTC C0527 along with DTC C0532? Go to Step 5  Go to Step 6 
4  Perform the diagnostic procedure for DTC C0522. Refer to DTC C0522 .
Did you find and correct the condition?		 Go to Step 8  Go to Step 6 
5  Perform the diagnostic procedure for DTC C0527. Refer to DTC C0527 .
Did you find and correct the condition?		 Go to Step 8  Go to Step 6 
6 Inspect for poor connections at the rear wheel steering control module and the rear wheel position sensor and rear wheel steering motor connectors. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition ?		 Go to Step 8  Go to Step 7 
7
IMPORTANT: Perform the Learn Alignment procedure. Refer toMeasuring Wheel Alignment (w/Rear Wheel Steering)Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.
Replace the rear wheel steering module. Refer to Rear Wheel Steering Control Module Replacement Did you complete the replacement?		 Go to Step 8   
8
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals