LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 995 (HVAC Systems - Automatic) >> Repair Instructions >> Air Temperature Actuator Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the left air temperature actuator (2) to the HVAC module assembly (3).
    Fig 1: Installing Left Air Temperature Actuator To HVAC Module Assembly
    GM826793Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws to the left air temperature actuator (2).

    Tighten:  Tighten the screws to 2 N.m (18 lb ft).

  3. Install the electrical connector (1) to the left air temperature actuator (2).
  4. Install the I/P insulator panel. Refer to Insulator Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
  5. Install the center console, if equipped. Refer to Console Replacement (w/Console Mounting Bracket) or Console Replacement (w/o Console Mounting Bracket) .
  6. Reprogram the left air temperature actuator. Refer to Re-Calibrating Actuators .
scientia non olet · About LEMON Manuals