LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 995 (HVAC Systems - Automatic) >> Diagnostic Information and Procedures >> Air Recirculation Malfunction

Air Recirculation Malfunction

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Air Recirculation Malfunction

Step Action Yes No
Schematic Reference: HVAC Schematics 
Connector End View Reference:  HVAC Connector End Views  
DEFINITION: Air recirculation is inoperative or is always ON.
1 Did you perform the HVAC Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - HVAC Systems - Automatic 
2
  1. Turn ON the ignition, with the engine OFF.
  2. With a scan tool observe the Recirculate Switch Parameter.
  3. Activate the recirculation switch.
Does the scan tool indicate that the Recirculate Switch Parameter changes state?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Inspect for poor connections at the harness connector of the HVAC control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 5  Go to Step 4 
4 Replace the HVAC control module. Refer to HVAC Control Module Replacement .
Did you complete the replacement?
Go to Step 5  -
5 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2