LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Stub Shaft Housing Replacement (680 Gear) >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Grease the stub shaft seal with the special grease supplied with the new stub shaft housing.
  2. Install the new stub shaft housing O-rings (1) (2).
    Fig 1: Installing The Stub Shaft Housing Onto The Steering Gear (680 Gear)
    GM725641Courtesy of GENERAL MOTORS CORP.
  3. Install the stub shaft housing (3) onto the steering gear.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the stub shaft housing bolts (4) into the stub shaft housing (34).

    Tighten:  Tighten the bolts to 55.0-70.0 N.m (40.5-51.6 lb ft).

scientia non olet · About LEMON Manuals