Assembly Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Inspect the cylinder lines (1) for the following items:
- Cracks
- Dents
- Damage to the threads
Fig 1: Cylinder Line Assemblies & Rack & Pinion Gear Assembly
Courtesy of GENERAL MOTORS CORP.
Replace the parts as needed.
Install the new O-ring seals (1) to the valve end of the cylinder lines.

Fig 2: View Of O-Ring Seals At Valve End Of Lines (Quiet Valve)
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer toFastener Notice in Cautions and Notices.

Fig 3: Cylinder Line Assemblies & Rack & Pinion Gear Assembly

Courtesy of GENERAL MOTORS CORP.

Install the cylinder line assemblies (1) to the gear assembly (2).
Tighten
- Tighten the valve end fittings to 17 N.m (13 lb ft)
- Tighten the cylinder end fittings to 27 N.m (20 lb ft)