LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Rack and Pinion Outer Tie Rod End Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Support the vehicle with suitable safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    3. Fig 1: Removing The Torque Prevailing Nut From Outer Tie Rod Stud
    GM417924Courtesy of GENERAL MOTORS CORP.
  3. Remove the torque prevailing nut from outer tie rod stud.
    4. Fig 2: Loosening Jam Nut
    GM470656Courtesy of GENERAL MOTORS CORP.
  4. Loosen the jam nut (2) on the inner tie rod assembly (1).
    5. Fig 3: Removing Outer Tie Rod Assembly From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
  5. Remove the outer tie rod assembly (2) from the steering knuckle (1) using J 24319-01.
    6. Fig 4: Removing The Outer Tie Rod Assembly From The Inner Tie Rod Assembly
    GM470661Courtesy of GENERAL MOTORS CORP.
  6. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).
scientia non olet · About LEMON Manuals