Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Connect the outer tie rod assembly (3) to the inner tie rod (1). Do not tighten the jam nut (2).

Fig 1: Connecting The Outer Tie Rod Assembly To The Inner Tie Rod
Courtesy of GENERAL MOTORS CORP.
Install the tie rod seal (2) to the outer tie rod assembly (1).

Fig 2: Installing The Tie Rod Seal To The Outer Tie Rod Assembly
Courtesy of GENERAL MOTORS CORP.
Connect the outer tie rod assembly (1) to the steering knuckle (2).
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the torque prevailing nut (3) to the outer tie rod stud (1).
Tighten: Tighten the torque prevailing nut (3) to 50 N.m (37 lb ft).

IMPORTANT: Be sure the rack and pinion boot is not twisted after the toe adjustment.

Check the wheel alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.