LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Power Steering System) >> Repair Instructions >> Power Steering Pump Wiring Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering wiring harness to the vehicle.
  2. Connect the power steering pump wiring harness electrical connector (3) to the power steering pump (4).
    Fig 1: Connecting Power Steering Pump Wiring Harness Electrical Connector To Power Steering Pump
    GM1237574Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical wiring harness clip (4) to the bracket.
    Fig 2: Installing Electrical Wiring Harness Clip To The Bracket
    GM1430004Courtesy of GENERAL MOTORS CORP.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolt retaining the wiring harness bracket (3) to the engine block.

    Tighten:  Tighten the bolt retaining the ground to the engine block to 9 N.m (80 lb in).

    5. Fig 3: Connecting Electrical Connectors To Wiring Harness
    GM1430007Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connectors (2) to the wiring harness.
  6. Install the coolant surge tank to the vehicle. Refer to Surge Tank Replacement in Engine Cooling.
  7. Connect the energy storage box after servicing the vehicle. Refer to Energy Storage Box (ESB) Service Disconnect/Connect (5.3L Engine w/RPO HP2) in Engine Electrical.
scientia non olet · About LEMON Manuals