Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Place a drain pan under the vehicle.
Remove the power steering pulley. Refer to Power Steering Pulley Replacement .
Remove the bolt retaining the battery junction block from the power steering bracket.

Fig 1: Removing Bolt Retaining The Battery Junction Block From The Power Steering Bracket (6.6L Diesel)
Courtesy of GENERAL MOTORS CORP.
Remove the bolts (1) from the rear of the pump.

Fig 2: Removing Bolts From The Rear Of The Pump (6.6L Diesel)
Courtesy of GENERAL MOTORS CORP.
Remove the bolts (2) from the front of the pump.

Fig 3: Removing Bolts From The Front Of The Pump (6.6L Diesel)
Courtesy of GENERAL MOTORS CORP.
Remove the power steering pump mounting bracket retaining bolts to gain access to the power steering hoses.

Fig 4: View Of Power Steering Return Hoses, Clamps & Power Steering Pump

Courtesy of GENERAL MOTORS CORP.

Remove the power steering return hoses (2,4) from the power steering pump.
Remove the power steering pressure hose (2) from the power steering pump.

Fig 5: View Of Power Steering Pressure Hose & Power Steering Pump
Courtesy of GENERAL MOTORS CORP.
Remove the power steering pump from the vehicle.
Remove the rear bracket from the power steering pump.