Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Installing Hoses Without Twists or Bends Notice in Cautions and Notices.

Route the hose in the same position the hose occupied prior to removal.
Install the power steering gear outlet hose (3) to the power steering pump (1).
Position the clamp at the end of the hose.

Fig 1: Installing The Power Steering Gear Outlet Hose To The Power Steering Pump (Recirculating Ball)
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the power steering gear outlet hose to the power steering gear.
Tighten: Tighten the outlet hose fitting to 28 N.m (20 lb ft).
Remove the drain pan from under the vehicle.
Bleed the power steering system. Refer to Bleeding the Power Steering System .